ITW Red Head Hammer-Set Anchor Installation Instructions

QuickMenu Save Document

Hammer-Set Anchor

Product Information Suggested/Ordering Information Performance Data Approval Listings

	SUGGESTED SPECIFICATIONS
		1. Drill proper size hole through material to be fastened into base material (See Chart for bit size).
		2. Clean hole.
		3. Insert Hammer-Set into hole until head of anchor body is flush with material to be fastened. Tap the nail until flush with head of anchor. Ensure minimum embedment is 1/4" deeper than anchor embedment. Be sure head is firmly against fixture.
		4. Anchor is now set. NOT RECOMMENDED FOR OVERHEARD Download PDF of Installation Instructions
Hammer-Set Anchor Product Information Selection and Order Information Installation Instructions Performance Data Approvals and Listing

ITW Red Head • 2171 Executive Drive • Addison, IL 60101 • 630-350-0370