header

or go to the Advance Search
QuickMenu Save Document

 C6 Adhesive Anchoring System
INSTALLATION INSTRUCTIONS

epcon_c6prod2e.jpg (4526 bytes) 1. Drill 1/16" oversize diameter holes for 1/4"–1/2" diameter threaded rods and #3 rebar. Drill 1/8" oversize diameter holes for 5/8"–1-1/4" diameter threaded rods, #4 rebar, grout filled blocks and brick pinning. Clean out hold from bottom with forced air. Complete hole preparation with brush and repeat cleaning with forced air (leave no dust or slurry).
epcon_c6prod2f.jpg (4016 bytes) 2. When starting new cartridge or new nozzle,
dispense and discard enough adhesive until
uniform light grey color is achieved. Insert the nozzle into the bottom of the hole and fill to
1/2 the hole depth.
epcon_c6prod2g.jpg (3958 bytes) 3. Insert rod slowly by hand into the bottom of the hole with a slow twisting motion. This insures adhesive fills voids and crevices and uniformly coats the anchor rod.
epcon_c6prod2h.jpg (4203 bytes) 4. See table for working times and curring times. After the suggested cure time is met, install and tighten fixture into place.

WARNING: Instruction Insert enclosed in carton to be distributed with each cartridge

WARNING: Manufacturer instructions must be followed

C6 Fast Curing Epoxy
Product Information and Advantages
Suggested Specifications
Applications, Features and Installation Instructions
Ordering Information and Estimating Tables 18 oz.
Performance Data (3 pages) : Watch Training Video : Approval and Listings

ITW Red Head • 2171 Executive Drive • Addison, IL 60101 • 630-350-0370
copyright © 2010 Illinois Tool Works, Inc.